|
| Error message when building |
 |
Thu, 7 Feb 2008 11:26:09 -0800 |
I keep getting this message when I use Burn to Disc - then hit build.
"The bit rate at 00:00:07:11 in timeline is too high for DVD. Lower the bit
rate by reencoding or removing content from the timeline".
|
| Post Reply
|
| Re: Error message when building |
 |
Thu, 7 Feb 2008 13:46:53 -0800 |
The maximum bit rate the DVD-Video spec allows for video plus audio is 9.8Mb/s.
Normally Encore's automatic transcoding shouldn't exceed this, but there is a
small chance of a fluke. You could try to let Encore do the transcoding again.
Set the maximum bit rate to 7Mb/s.
|
| Post Reply
|
| Re: Error message when building |
 |
Thu, 7 Feb 2008 15:05:26 -0800 |
Ruud:
|
| Post Reply
|
| Re: Error message when building |
 |
Fri, 8 Feb 2008 03:48:57 -0800 |
For some reason on this video automatic did not work.
What is your preference setting for maximum combined bitrate?
|
| Post Reply
|
| Re: Error message when building |
 |
Thu, 13 Mar 2008 18:26:38 -070 |
|
| Post Reply
|
|
|
|
|
|
|
|
|
|