|
| Imported a m2v-file into Adobe 1.51, but then problems |
 |
Mon, 12 Nov 2007 08:59:18 -080 |
Dear all,
I imported a m2v-file after I demuxed it into Encore 1.51. I can put it in the
Project without any problem. But when I put it in the timeline it gave the
following error:
Sorry, an abnormal condition has been detected. Before quitting, you have one
chance to save your project (don't use the same name is the original).
I gets into the timeline, but further on I can't work with it. What's going on
here? It's a good mpeg-file. I want the software to work, as the User Guide says
it can handle m2v-files. I just bought the software :(
Kind regards,
|
| Post Reply
|
| Re: Imported a m2v-file into Adobe 1.51, but then problems |
 |
Mon, 12 Nov 2007 09:04:47 -080 |
I just bought the software
|
| Post Reply
|
| Re: Imported a m2v-file into Adobe 1.51, but then problems |
 |
Mon, 12 Nov 2007 09:11:36 -080 |
Yes, on eBay. When you have small budget...
Isn't it sufficient enough?
|
| Post Reply
|
| Re: Imported a m2v-file into Adobe 1.51, but then problems |
 |
Mon, 12 Nov 2007 09:19:51 -080 |
Concerning your name: Looks like you're from Holland. I am.
Guilty as charged. ;)
When you check the .m2v file with Bitrate Viewer
<http://www.tecoltd.com/bitratev.htm> what does it report in the
"peak" bit rate field and what does it say in the box on the lower
right (dimensions, nominal bit rate, etc.).
|
| Post Reply
|
| Re: Imported a m2v-file into Adobe 1.51, but then problems |
 |
Mon, 12 Nov 2007 09:52:30 -080 |
Bitrate Peak 8032
Bitrate Average 6928
Q.level Peak 19.23
Q.level Average 2.43
Num. of picture read: 78832
Stream type: MPEG-2 MP@ML VBR
Resolution: 720*576
Aspect ratio: 4:3 Generic
Framerate: 25.00
Nom. bitrate: 7544800 Bit/Sec
VBV buffer size: 112
Constrained param. flag: No
Chroma format: 4:2:0
DCT precision: 9
Pic. structure: Frame
Field topfirst: No
DCT type: Field
Quantscale: Nonlinear
Scan type: Alternate
Frame type: Interlaced
Notes:
|
| Post Reply
|
|
|
|
|
|
|
|
|
|