|
| Re: PLEASE HELP ME. |
 |
Tue, 1 Apr 2008 03:48:03 +0000 |
Don't plot directly to a plotter. Use PC3 files. and also use Named Page
Setups in your drawing so you can plot the same way you did last time. Use
the PLOTTERMANAGER command to create PC3 files. Use the PAGESETUP command
to set your page up for plotting the way you want. You can plot the same
sheet in multiple ways if you want to and then have the setup stored in the
drawing forever.
--
_________________________
Bill DeShawn
bdeshawn@nospamsterling.net
http://my.sterling.net/~bdeshawn
Notice: New LISP tool for Landscape
Design and for ATTEXT users.
Measure and Divide with attributes!!
<AGNES> wrote in message news:5890710@discussion.autodesk.com...
I AM USING PLOTTER T1100 44INCH TO PLOT IN AUTOCAD LT 2004 . BUT ONLY CAN
USE IN PAPER SHEET . WHEN I USE A0 ROLL FEED TO PLOT A1, IT CANNOT AUTO
ROTATE TO PLACE IT SHOULD BE.. IT ALWAYS GO BACK TO PORTRAIT SO IT WASTE THE
OTHER SPACE OF PAPER ..
?? PLEASE HELP TO SOLVE THIS PROBLEM??
|
| Post Reply
|
|
|
|
|
|
|
|
|
|