RE: Communication between Palm T | X and microcontroller
PIC18F4550.

You cannot get from here to there.  The PIC has a UART mode Page 242 of the
datasheet (book) http://ww1.microchip.com/downloads/en/DeviceDoc/39632b.pdf,
allowing you to communicate via serial.

Neither unit can become the master, so they cannot communicate via USB.


Sincerely,

    Dennis Ideue,

    Advanced Merchant Solutions, Inc.
    http://www.MerchantAnywhere.com
    PalmSource Software Champion
    Microsoft Mobile Solutions Partner

    T: 714.449.0211
    F: 800.360.7951



IMPORTANT NOTICE: The information contained in this document and attachments
is confidential and intended only for the person(s) named above. If you are
not the intended recipient you are hereby notified that any disclosure,
copying, distribution, or any other use of the information is strictly
prohibited. If you have received this document by mistake, please notify the
sender immediately and destroy this document and attachments without making
any copy of any kind.


-----Original Message-----
From: %%email.bounce%@ [mailto:%%email.bounce%@] On Behalf Of
joaopaulojprf@yahoo.com.br
Sent: Monday, September 17, 2007 2:34 PM
To: Communication Developer Forum
Subject: Communication between Palm T | X and microcontroller PIC18F4550.

Hello,

I want to communicate PIC18F4550 with Palm T | X using USB communication,
but both are peripherals. I noticed that PIC18F4550 can only be a slave. Is
it possible the Palm T | X to be a host on USB communication? How I can
communicate these devices using another protocol? Any information helps.

Thanks,

João Paulo.

--
For information on using the ACCESS Developer Forums, or to unsubscribe,
please see http://www.access-company.com/developers/forums/