Re: Missing text from Calc-as-you-go

The second line is of no use.  While in Edit mode, you can add, delete 
and move Command buttons around and resize.  To maximize the command, 
create a new toolbar and add Status Mode and size as needed.

To be in edit mode, you must have the Commands button selected in the 
Cutomization dialog after selecting the toolbar to edit.

Kim Frankcombe wrote:
> I have Calc-as-you-go turned on so that I get summary statistics on the 
> selected block shown down on the application bar. However depending on 
> the numbers involved I am unable to see the whole line and the Max and 
> Min usually disappear off the right hand side of the screen. It is not a 
> font size vs screen resolution issue as I just doubled the screen pixels 
> and there is no change. I've tried making the application bar 2 lines 
> high but it doesn't wrap. I can't move the divider between it and the 
> Keyboard status buttons. I can't see anywhere where I can change the 
> font for the application bar. There was a time back in QPro 8 or 9 maybe 
> when I could see the whole line but for Ver 12 and I think Ver 10 I have 
> had this problem - I'm a patient man!! Any tips?

Just to confirm (as you indicated), in QP8 I can easily move the divider on the

status bar to the left to see all 5 stats.

Uli

Kim:
> Any tips?
>
None from me.-(}
It's the same here . . .
-- 
Good wishes!
Roy Lewis
C_Tech volunteer
(UK)

I have Calc-as-you-go turned on so that I get summary statistics on the 
selected block shown down on the application bar. However depending on 
the numbers involved I am unable to see the whole line and the Max and 
Min usually disappear off the right hand side of the screen. It is not a 
font size vs screen resolution issue as I just doubled the screen pixels 
and there is no change. I've tried making the application bar 2 lines 
high but it doesn't wrap. I can't move the divider between it and the 
Keyboard status buttons. I can't see anywhere where I can change the 
font for the application bar. There was a time back in QPro 8 or 9 maybe 
when I could see the whole line but for Ver 12 and I think Ver 10 I have 
had this problem - I'm a patient man!! Any tips?

It can be a bit tricky to edit a toolbar item.  The critical part is to 
be in Edit mode.  This is done with the toolbar selected in Tools > 
Customize, and then the Commands.  If you then click a toolbar item that 
you added, it should be highlighted in the Commands list.  To resize, 
move cursor around the end and it will turn into <->.

If all else fails, email me and I will send you an exported toolbar that 
is one line long with this control.