Admin Studio 8 and VMWare - disabled "build"
option

Thought I would try a post here on the off chance that someone has seen this
problem before, although it doesn't appear that this forum is very active.

Trying to use repackager to build an msi for an application.  Installing on
VMWare WXP clean VM running repackager from a VMWare share.  Using
installation monitoring option, the process runs, but after completing the
install, and running the Installation Intent scan, I am unable to build the
MSI because the "build" option is disabled (greyed out).  No error
messages
or anything, just not working.

Any insights as to what may be causing this?




-- 

Dennis R. Crowther, CNE
crowther@salud_NOSPAM_.unm.edu

Dennis,

It appears that in the past few days you have not received a response to your 
posting.  That concerns us, and has triggered this automated reply.

Has your problem been resolved? If not, you might try one of the following
options:
 
- Do a search of our knowledgebase at
http://support.novell.com/search/kb_index.jsp 
- Check all of the other support tools and options available at 
http://support.novell.com.
- You could also try posting your message again. Make sure it is posted in the 
correct newsgroup. (http://support.novell.com/forums)

Be sure to read the forum FAQ about what to expect in the way of responses:  
http://support.novell.com/forums/faq_general.html

If this is a reply to a duplicate posting, please ignore and accept our
apologies 
and rest assured we will issue a stern reprimand to our posting bot.

Good luck!

Your Novell Product Support Forums Team
http://support.novell.com/forums/