|
| Config Management - admin studio |
 |
Tue, 11 Mar 2008 04:30:34 GMT |
Cannot find a forum for Zenworks 10, configuration management. Getting
ready to migrate from 7.1
AdminStudio Zenworks editions needs to login into the Zenworks server
and fails this, looking for how to find out why?
|
| Post Reply
|
| Re: Config Management - admin studio |
 |
Wed, 12 Mar 2008 18:11:36 GMT |
On Tue, 11 Mar 2008 04:30:34 GMT, mcu wrote:
> AdminStudio Zenworks editions needs to login into the Zenworks server
> and fails this, looking for how to find out why?
so you downloaded the new version for zcm 10, installed it and pointed it
to the zcm server?
--
Marcus Breiden
If you are asked to email me information please remove the - in my e-mail
address.
The content of this mail is my private and personal opinion.
|
| Post Reply
|
| Re: Config Management - admin studio |
 |
Wed, 19 Mar 2008 10:35:04 GMT |
Marcus Breiden wrote:
> On Tue, 11 Mar 2008 04:30:34 GMT, mcu wrote:
>
>> AdminStudio Zenworks editions needs to login into the Zenworks server
>> and fails this, looking for how to find out why?
>
> so you downloaded the new version for zcm 10, installed it and pointed it
> to the zcm server?
I deleted the original message as I found the forum for Configuration
Manager and I didn't think there were any responses at the time.
There are messages in that forum with this problem, only fixed with a
reinstall.
Yes download CM sp1 installed to Linux and then tried connecting to it
with Adminstudio (key obtained from their site). Kept asking for login
credentials but did not accept. Unfortunately haven't got back to it
again since. 7.1 still running OK, but will need zcm for Vista
|
| Post Reply
|
|
|
|
|
|
|
|
|
|