|
| loses mouse |
 |
Tue, 15 Jan 2008 02:40:45 GMT |
Trying to install rc4 on dell laptop. installed rc2 no problems with
/smp /fs standard mouse driver (amouse will not work with my logitech
trackball). In rc4 the mouse works in the setup but once the instal is
over does not work. Also is there a way to get the touchpad to work
(which driver in instal)? I show no errors on bootup.
jim dalton
--
|
| Post Reply
|
| Re: loses mouse |
 |
Tue, 15 Jan 2008 21:31:57 GMT |
RC4 installs AMOUSE as default mouse driver, check to ensure you did not
install Amouse by accident.
|
| Post Reply
|
| Re: loses mouse |
 |
Thu, 17 Jan 2008 10:26:44 -050 |
I've been using AMouse with a Logitech Cordless Optical Trackman for years.
-=-
Alan
On 01/17/08 09:51 am James Dalton wrote:
> I made sure it was the standard mouse driver because amouse does not
> seem to work with a logitech trackball.
>> RC4 installs AMOUSE as default mouse driver, check to ensure you did
not
|
| Post Reply
|
| Re: loses mouse |
 |
Thu, 17 Jan 2008 10:47:52 -060 |
James Dalton wrote:
> Trying to install rc4 on dell laptop. installed rc2 no problems with
> /smp /fs standard mouse driver (amouse will not work with my logitech
> trackball). In rc4 the mouse works in the setup but once the instal is
> over does not work. Also is there a way to get the touchpad to work
> (which driver in instal)? I show no errors on bootup.
>
> jim dalton
I have a Toshiba laptop and all it takes is knowing what keyboard
combination turns the touchpad on and off. The same keyboard
combination works for both eCS and Windows. On my daughters HP, it was
a button located above the touchpad. Again this worked for both eCS and
Windows.
Even though you say you did not install the amouse driver, I would boot
to your maintenance menu at bootup (alt+f1) and then select boot to a
command prompt. At the command prompt, type tedit config.sys. Once the
config.sys is loaded, scroll down the cofig.sys and look for your mouse
driver. If you find
DEVICE=C:\ECS\SYSTEM\AMouse\AMOUSE.SYS
then the amouse driver was installed. If found, this could indicate
that the install routine failed to install the normal IBM driver that
you selected.
|
| Post Reply
|
| Re: loses mouse |
 |
Thu, 17 Jan 2008 14:51:22 GMT |
I made sure it was the standard mouse driver because amouse does not
seem to work with a logitech trackball.
jim
On Tue, 15 Jan 2008 21:31:57 UTC, Synper311@aol.com (Brett Carlock)
wrote:
> RC4 installs AMOUSE as default mouse driver, check to ensure you did not
> install Amouse by accident.
>
--
|
| Post Reply
|
|
|
|
|
|
|
|
|
|