DSL

I am trying to get eCS 1.2 to connect to the internet thru a DSL line.  I 
followed all the instructions on pages 22 and 23 of the 1.2 manual without 
success.  I filled out all the blanks on the OS2 installer.  (This is 
being sent from my WinXP box, which, of course, was simple to set up.) I 
would appreciate someone telling me what to do.  Thanks, Mark

On Mon, 17 Dec 2007 01:35:55 UTC, markrussell1@verizon.net (Marcus H. Russell) 
wrote:

> I am trying to get eCS 1.2 to connect to the internet thru a DSL line.  I 
> followed all the instructions on pages 22 and 23 of the 1.2 manual without

> success.  I filled out all the blanks on the OS2 installer.  (This is 
> being sent from my WinXP box, which, of course, was simple to set up.) I 
> would appreciate someone telling me what to do.  Thanks, Mark

Need more information.  What error(s) are you getting, and at what
point?  

-- 
Alex Taylor
http://www.cs-club.org/~alex

No error messages ... judt no connection.

Sorry, the following is at boot:  "could not find entry in
protocol.ini"

Hi Marcus

Marcus H. Russell wrote:
> No error messages ... judt no connection.
> 


A starting point:-

How are you trying to effect a connection?


Followed by:-

What hardware and software is involved?

Do any drivers involved load OK at boot?



Responses to the above may help effect a "cure"  :-)

Regards

Pete